Datasheet
ORDERING GUIDE
Temperature Package Package
Model Range Description Options
AD813AN –40°C to +85°C 14-Lead Plastic DIP N-14
AD813AR-14 –40°C to +85°C 14-Lead Plastic SOIC R-14
AD813ACHIPS –40°C to +85°C Die Form
AD813AR-REEL 13" REEL
AD813AR-REEL7 7" REEL
5962-9559601M2A* –55°C to +125°C 20-Lead LCC
*Refer to official DSCC drawing for tested specifications and pin configuration.
ABSOLUTE MAXIMUM RATINGS
1
Supply Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ±18 V
Internal Power Dissipation
2
Plastic (N) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1.6 Watts
Small Outline (R) . . . . . . . . . . . . . . . . . . . . . . . . . 1.0 Watts
Input Voltage (Common Mode) . . . . . . . . . . . . . . . . . . . ±V
S
Differential Input Voltage . . . . . . . . . . . . . . . . . . . . . . . . ±6V
Output Short Circuit Duration
. . . . . . . . . . . . . . . . . . . . . . . Observe Power Derating Curves
Storage Temperature Range N, R . . . . . . . . –65°C to +125°C
Operating Temperature Range
AD813A . . . . . . . . . . . . . . . . . . . . . . . . . . . –40°C to +85°C
Lead Temperature Range (Soldering 10 sec) . . . . . . . +300°C
NOTES
1
Stresses above those listed under Absolute Maximum Ratings may cause perma-
nent damage to the device. This is a stress rating only; functional operation of the
device at these or any other conditions above those indicated in the operational
section of this specification is not implied. Exposure to absolute maximum rating
conditions for extended periods may affect device reliability.
2
Specification is for device in free air:
14-Lead Plastic DIP Package: θ
JA
= 75°C/W
14-Lead SOIC Package: θ
JA
= 120°C/W
AD813
Model AD813A
Conditions V
S
Min Typ Max Units
MATCHING CHARACTERISTICS
Dynamic
Crosstalk G = +2, f = 5 MHz +5 V, +3 V –65 dB
Gain Flatness Match G = +2, f = 20 MHz +5 V, +3 V 0.1 dB
DC
Input Offset Voltage T
MIN
–T
MAX
+5 V, +3 V 0.5 3.5 mV
–Input Bias Current T
MIN
–T
MAX
+5 V, +3 V 2 25 µA
POWER SUPPLY
Operating Range 2.4 36 V
Quiescent Current Per Amplifier +5 V 3.2 4.0 mA
+3 V 3.0 4.0 mA
T
MIN
–T
MAX
+5 V 5.0 mA
Quiescent Current, Powered Down Per Amplifier +5 V 0.4 0.6 mA
+3 V 0.4 0.5 mA
Power Supply Rejection Ratio
Input Offset Voltage V
S
= +3.0 V to +30 V 76 dB
–Input Current 0.3 µA/V
+Input Current 0.005 µA/V
DISABLE CHARACTERISTICS
Off Isolation f = 5 MHz +5 V, +3 V –55 dB
Off Output Impedance G = +1 +5 V, +3 V 13 pF
Channel-to-Channel 2 or 3 Channel +5 V, +3 V –65 dB
Isolation Mux, f = 5 MHz
Turn-On Time +5 V, +3 V 100 ns
Turn-Off Time 80 ns
TRANSISTOR COUNT 111
NOTES
1
Slew rate measurement is based on 10% to 90% rise time in the specified closed-loop gain.
2
Single supply differential gain and phase are measured with the ac coupled circuit of Figure 52.
Specifications subject to change without notice.
–5–
REV. B