Datasheet

AD8106/AD8107
Rev. 0 | Page 3 of 28
SPECIFICATIONS
V
S
= ±5 V, T
A
= 25°C, R
L
= 1 kΩ, unless otherwise noted.
Table 1.
Parameter Conditions Min Typ Max Unit Reference
DYNAMIC PERFORMANCE
−3 dB Bandwidth 200 mV p-p, R
L
= 150 Ω 300/190 390/260 MHz Figure 10, Figure 16
2 V p-p, R
L
= 150 Ω 150 MHz Figure 10, Figure 16
Propagation Delay 2 V p-p, R
L
= 150 Ω 5 ns
Slew Rate 2 V step, R
L
= 150 Ω 500 V/μs
Settling Time 0.1%, 2 V step, R
L
= 150 Ω 40 ns Figure 15, Figure 21
Gain Flatness 0.05 dB, 200 mV p-p, R
L
= 150 Ω 60/40 MHz Figure 10, Figure 16
0.05 dB, 2 V p-p, R
L
= 150 Ω 65/40 MHz Figure 10, Figure 16
0.1 dB, 200 mV p-p, R
L
= 150 Ω 80/57 MHz Figure 10, Figure 16
0.1 dB, 2 V p-p, R
L
= 150 Ω 70/57 MHz Figure 10, Figure 16
NOISE/DISTORTION PERFORMANCE
Differential Gain Error NTSC or PAL, R
L
= 1 kΩ 0.01 %
NTSC or PAL, R
L
= 150 Ω 0.02 %
Differential Phase Error NTSC or PAL, R
L
= 1 kΩ 0.01 Degrees
NTSC or PAL, R
L
= 150 Ω 0.02 Degrees
Crosstalk, All Hostile f = 5 MHz 78/85 dB Figure 11, Figure 17
f = 10 MHz 70/80 dB Figure 11, Figure 17
Off Isolation, Input/Output f = 10 MHz, R
L
= 150 Ω, one channel 93/99 dB Figure 26, Figure 32
Input Voltage Noise 0.01 MHz to 50 MHz 15 nV/√Hz Figure 23, Figure 29
DC PERFORMANCE
Gain Error R
L
= 1 kΩ 0.04/0.1 0.07/0.5 %
R
L
= 150 Ω 0.15/0.25 %
Gain Matching No load, channel-to-channel 0.02/1.0 %
R
L
= 1 kΩ, channel-to-channel 0.09/1.0 %
Gain Temperature Coefficient 0.5/8 ppm/°C
OUTPUT CHARACTERISTICS
Output Impedance DC, enabled 0.2 Ω Figure 27, Figure 33
Disabled 10/0.001 MΩ Figure 24, Figure 30
Output Disable Capacitance Disabled 2 pF
Output Leakage Current Disabled, AD8106 only 1/NA μA
Output Voltage Range No load ±2.5 ±3 V
Output Current 20 40 mA
Short-Circuit Current 65 mA
INPUT CHARACTERISTICS
Input Offset Voltage Worst case (all configurations) 5 20 mV Figure 38, Figure 44
Temperature coefficient 12 μV/°C Figure 39, Figure 45
Input Voltage Range ±2.5/±1.25 ±3/±1.5 V
Input Capacitance Any switch configuration 2.5 pF
Input Resistance 1 10 MΩ
Input Bias Current Per output selected 2 5 μA
SWITCHING CHARACTERISTICS
Enable On Time 60 ns
Switching Time, 2 V Step
50%
UPDATE
to 1% settling
25 ns
Switching Transient (Glitch) Measured at output 20/30 mV p-p Figure 25, Figure 31