Datasheet

AD7764
Rev. A | Page 30 of 32
GAIN REGISTER—ADDRESS 0x0004
Non-Bit-Mapped, Default Value 0xA000
The gain register is scaled such that 0x8000 corresponds to a
gain of 1.0. The default value of this register is 1.25 (0xA000).
This results in a full-scale digital output when the input is at
80% of V
REF
+, tying in with the maximum analog input range of
±80% of V
REF
+ p-p.
OVERRANGE REGISTER—ADDRESS 0x0005
Non-Bit-Mapped, Default Value 0xCCCC
The overrange register value is compared with the output of the
first decimation filter to obtain an overload indication with
minimum propagation delay. This is prior to any gain scaling.
The default value is 0xCCCC, which corresponds to 80% of
V
REF
+ (the maximum permitted analog input voltage). Assuming
V
REF
+ = 4.096 V, the bit is then set when the input voltage exceeds
approximately 6.55 V p-p differential. The over-range bit is set
immediately if the analog input voltage exceeds 100% of V
REF
+
for more than four consecutive samples at the modulator rate.