Datasheet

AD7150
Rev. 0 | Page 19 of 28
CONFIGURATION REGISTER
Address Pointer 0x0F
8 Bits, Read/Write, Factory Preset 0x19
Table 12. Configuration Register Bit Map
Bit Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
Mnemonic ThrFixed ThrMD1 ThrMD0 EnCh1 EnCh2 MD2 MD1 MD0
Default 0 0 0 1 1 0 0 1
Table 13.Configuration Register Bit Descriptions
Bit Mnemonic Description
7 ThrFixed
ThrFixed = 1 sets the fixed threshold mode. The outputs reflect comparison of data and a fixed (constant) value
of the threshold registers.
ThrFixed = 0 sets the adaptive threshold mode. The outputs reflect comparison of data to the adaptive
thresholds. The adaptive threshold is set dynamically, based on the history of the previous data.
These bits set the output comparators mode.
Output Active When
ThrMD1 ThrMD0 Threshold Mode Adaptive Threshold Mode Fixed Threshold Mode
0 0 Negative data < average – sensitivity Data < Threshold
0 1 Positive data > average + sensitivity Data > Threshold
1 0 In-Window data > average – sensitivity
AND
data < average + sensitivity
‒
6
5
ThrMD1
ThrMD0
1 1 Out-Window data < average – sensitivity
OR
data > average + sensitivity
–
4 EnCh1 Enables conversion on Channel 1.
3 EnCh2 Enables conversion on Channel 2.
Converter mode of operation setup.
MD2 MD1 MD0 Mode Description
0 0 0 Idle Part is fully powered up but performing no conversion.
0 0 1
Continuous
Conversion
Part is repeatedly performing conversions on the enabled
channel(s). If two channels are enabled, the part is
sequentially switching between them.
0 1 0 Single Conversion
Part performs a single conversion on the enabled channel. If
two channels are enabled, the part performs two
conversions, one on each channel. After finishing the
conversion(s), the part goes to the idle mode.
0 1 1 Power-Down
Powers down the on-chip circuits, except the digital
interface.
2
1
0
MD2
MD1
MD0
1 X X Reserved Do not use these modes.