Datasheet

AD588
Rev. L | Page 3 of 20
SPECIFICATIONS
Typical @ 25°C, 10 V output, V
S
= ±15 V, unless otherwise noted.
Specifications shown in boldface are tested on all production units at final electrical test. Results from those tests are used to calculate
outgoing quality levels. All minimum and maximum specifications are guaranteed, although only those shown in boldface are tested on
all production units.
Table 1.
AD588JQ/AQ AD588BQ/KQ AD588ARWZ
Parameter
1
Min Typ Max Min Typ Max Min Typ Max Unit
OUTPUT VOLTAGE ERROR
+10 V, −10 V Outputs
±3 −1 +1 −5 +5
mV
+5 V, −5 V Outputs
±3 −1 +1 −5 +5
mV
±5 V TRACKING MODE
Symmetry Error
±1.5 ±0.75 ±1.5
mV
OUTPUT VOLTAGE DRIFT
0°C to 70°C (J, K, B) ±2
±3 ±1.5
±2
±3
ppm/°C
−25°C to +85°C (A, B)
±3 ±3 ±3
ppm/°C
GAIN ADJ AND BAL ADJ
2
Trim Range ±4 ±4 ±4 mV
Input Resistance 150 150 150 kΩ
LINE REGULATION
T
MIN
to T
MAX
3
±200 ±200 ±200
μV/V
LOAD REGULATION
T
MIN
to T
MAX
+10 V Output, 0 mA < I
OUT
< 10 mA
±50 ±50 ±50
μV/mA
−10 V Output, −10 mA < I
OUT
< 0 mA
±50 ±50 ±50
μV/mA
SUPPLY CURRENT
T
MIN
to T
MAX
6
10
6
10
6
10
mA
Power Dissipation 180
300
180
300
180
300
mW
OUTPUT NOISE (Any Output)
0.1 Hz to 10 Hz 6 6 6 μV p-p
Spectral Density, 100 Hz 100 100 100 nV/√Hz
LONG-TERM STABILITY (@ 25°C) 15 15 15 ppm/1000 hr
BUFFER AMPLIFIERS
Offset Voltage 100 10 100 μV
Offset Voltage Drift 1 1 1 μV/°C
Bias Current 20 20 20 nA
Open-Loop Gain 110 110 110 dB
Output Current (A3, A4) −10 +10 −10 +10 −10 +10 mA
Common-Mode Rejection (A3, A4)
V
CM
= 1 V p-p 100 100 100 dB
Short Circuit Current 50 50 50 mA
TEMPERATURE RANGE
Specified Performance
J, K Grades 0 70 0 70 °C
A, B Grades −25 +85 −25 +85 −25 +85 °C
1
Specifications tested using ±5 V configuration, unless otherwise indicated. See through for output configurations at +10 V, −10 V, +5 V, −5 V
and ±5 V.
Figure 4 Figure 6
2
Gain and balance adjustments guaranteed capable of trimming output voltage error and symmetry error to zero.
3
For ±10 V output, ±V
S
can be as low as ±12 V. See for test conditions at various voltages. Table 3