Datasheet
Table Of Contents
- FEATURES
- APPLICATIONS
- FUNCTIONAL BLOCK DIAGRAM
- TABLE OF CONTENTS
- REVISION HISTORY
- GENERAL DESCRIPTION
- SPECIFICATIONS
- TIMING CHARACTERISTICS
- ABSOLUTE MAXIMUM RATINGS
- PIN CONFIGURATION AND FUNCTION DESCRIPTIONS
- TYPICAL PERFORMANCE CHARACTERISTICS
- TERMINOLOGY
- FUNCTIONAL DESCRIPTION
- INTERFACES
- DATA DECODING
- ADDRESS DECODING
- POWER SUPPLY DECOUPLING
- TYPICAL APPLICATION CIRCUIT
- OUTLINE DIMENSIONS
AD5378
Rev. A | Page 14 of 28
Pin Description
FIFOEN
FIFO Enable. Level sensitive, active high. When connected to DVDD, the internal FIFO is enabled, allowing the user to
write to the device at full speed. FIFO is available in both serial and parallel modes. The FIFOEN pin has an internal
1 MΩ pull-down resistor connected to ground, meaning that the FIFO is disabled by default.
RESET Asynchronous Digital Reset Input. Falling edge sensitive. If unused, RESET can be left unconnected; an internal pull-up
resistor (1 MΩ) ensures that the RESET
input is held high. The function of this pin is equivalent to that of the power-on
reset generator. When this pin is taken low, the AD5378 state machine initiates a reset sequence to digitally reset the
x1, m, c, and x2 registers to their default power-on values. This sequence takes 100 μs (typ). Furthermore, the input to
each of the DAC output buffer stages, VOUT0 to VOUT31, is switched to the externally set potential on the relevant
REFGND pin. During RESET
, BUSY goes low and the parallel interface is disabled. All LDAC pulses are ignored until
BUSY goes high. When RESET goes high again, the DAC ouputs remain at REFGND until LDAC is taken low.
REFGNDA1 Reference Ground for DACs 0 to 5. VOUT0 to VOUT5 are referenced to this voltage.
REFGNDA2 Reference Ground for DACs 6 and 7. VOUT6 and VOUT7 are referenced to this voltage.
REFGNDB1 Reference Ground for DACs 8 to 13. VOUT8 to VOUT13 are referenced to this voltage.
REFGNDB2 Reference Ground for DACs 14 and 15. VOUT14 and VOUT15 are referenced to this voltage.
REFGNDC1 Reference Ground for DACs 16 to 21. VOUT16 to VOUT21 are referenced to this voltage.
REFGNDC2 Reference Ground for DACs 22 and 23. VOUT22 and VOUT23 are referenced to this voltage.
REFGNDD1 Reference Ground for DACs 24 to 29. VOUT24 to VOUT29 are referenced to this voltage.
REFGNDD2 Reference Ground for DACs 30 and 31. VOUT30 and VOUT31 are referenced to this voltage.
1
These serial interface signals do not require separate pins, but share parallel interface pins.