Datasheet

AD5362/AD5363
Rev. A | Page 4 of 28
SPECIFICATIONS
DV
CC
= 2.5 V to 5.5 V; V
DD
= 9 V to 16.5 V; V
SS
= −16.5 V to −4.5 V; V
REF
= 5 V; AGND = DGND = SIGGND0 = SIGGND1 = 0 V;
R
L
= open circuit; gain (M), offset (C), and DAC offset registers at default values; all specifications T
MIN
to T
MAX
, unless otherwise noted.
Table 2.
Parameter B Version
1
Unit Test Conditions/Comments
ACCURACY
Resolution 16 Bits AD5362
14 Bits AD5363
Integral Nonlinearity (INL) ±4 LSB max AD5362
±1 LSB max AD5363
Differential Nonlinearity (DNL) ±1 LSB max Guaranteed monotonic by design over temperature
Zero-Scale Error ±15 mV max Before calibration
Full-Scale Error ±20 mV max Before calibration
Gain Error 0.1 % FSR Before calibration
Zero-Scale Error
2
1 LSB typ After calibration
Full-Scale Error
2
1 LSB typ After calibration
Span Error of Offset DAC ±75 mV max See the Offset DACs section for details
VOUTx
3
Temperature Coefficient 5 ppm FSR/°C typ Includes linearity, offset, and gain drift
DC Crosstalk
2
180 μV max
Typically 20 μV; measured channel at midscale, full-scale
change on any other channel
REFERENCE INPUTS (VREF0, VREF1)
2
VREFx Input Current ±10 μA max Per input; typically ±30 nA
VREFx Range
2
2/5 V min/V max ±2% for specified operation
SIGGND0 AND SIGGND1 INPUTS
2
DC Input Impedance 50 kΩ min Typically 55 kΩ
Input Range ±0.5 V min/V max
SIGGNDx Gain 0.995/1.005 min/max
OUTPUT CHARACTERISTICS
2
Output Voltage Range V
SS
+ 1.4 V min I
LOAD
= 1 mA
V
DD
− 1.4 V max I
LOAD
= 1 mA
Nominal Output Voltage Range −10 to +10 V
Short-Circuit Current 15 mA max VOUTx
3
to DV
CC
, V
DD
, or V
SS
Load Current ±1 mA max
Capacitive Load 2200 pF max
DC Output Impedance 0.5 Ω max
MONITOR PIN (MON_OUT)
2
Output Impedance
DAC Output at Positive Full Scale 1000 Ω typ
DAC Output at Negative Full Scale 500 Ω typ
Three-State Leakage Current 100 nA typ
Continuous Current Limit 2 mA max
DIGITAL INPUTS
Input High Voltage 1.7 V min DV
CC
= 2.5 V to 3.6 V
2.0 V min DV
CC
= 3.6 V to 5.5 V
Input Low Voltage 0.8 V max DV
CC
= 2.5 V to 5.5 V
Input Current ±1 μA max
RESET
, SYNC, SDI, and SCLK pins
±20 μA max
CLR
, BIN/2SCOMP, and GPIO pins
Input Capacitance
2
10 pF max