Specifications

SECTION 12 ERROR CODES
67
GETTING STARTED
The user will need to type in the following instructions:
Note: You will NOT see the first few commands. Type
them in as instructed below and the program will then
begin showing instructions on the screen.
1. Type in @0 then ENTER it.
2. Type in id then ENTER it.
3. SMC40X-T should now be on the screen.
4. Type in ps, then Press Enter.
5. The Stored Program should have Started.
(The command PA will start a stored program if
a downloaded and auto stored program is
already loaded.)
6. If you have problems communicating,
power the controller down. Exit Hyper
Terminal and Start over from the beginning.
Power up the Controller and Start Hyper
Terminal.