Specifications

SECTION 2 QUICK START

STEP 8 - Download the Program ( the Envelope Icon Button )

STEP 9 - Run the Program

To run the

program just sent, select the Start Button (Traffic Signal Icon Button) which signals Green for GO.

STEP 10 - Switch Closure

After the sample program is written, you will need to close the switch on Input 1 to view the programmed

motion. The current to the step motor will be turned off whenever it is motionless. Once the switch has

been closed, the motor will move 400 steps, then an output will be activated for 1 second. This will happen

4 times automatically, and then the indexer will wait for a switch closure before repeating the same cycle.

Select the Send Button (Envelope Icon Button). This sends all 4 programs (Main, Programs 1, 2, & 3 to

the Driver Pack. The programs will reside in the nonvolatile memory, and will stay there until they are

overwritten, or deleted by the software. Once the program is sent, Click OK on the prompt button

Program Sent. (Note: Place a Branch Quit Statement at the end of every program before sending.)

êê