Installation Guide

ACCESSORY INSTALLATION - STELLA (Cont’d)
3 IG – PD-A20608 – Rev01
1. Cup holder
Tools: None
1.1. Snap cup-holder attachment onto the frame on the desired side.
3. Cane holder
Tools: 3 mm and 4 mm Allen keys
3.1 Slightly loosen the screw on the upper part
before snaping onto frame so that the angle
can be adjusted. Use 3 mm Allen key.
3.2 Slightly loosen the screw on the lower part
before snaping onto frame so that the angle
can be adjusted. Use 4 mm Allen key.
3.3 Snap both parts onto the frame as shown below.
3.4 Adjust angle of each part as needed.
3.5 Remove both parts.
3.6 Tighten screws.
3.7 Reinstall both parts at the same location as step 3.3.