Specifications

Installation
30
Vision
2
Operation/Reference Guide
Installing the V2-STORAGE-EXT810 External RAID Controller
The V2-STORAGE-EXT810 External RAID Controller is the external RAID card that connects to the
V2-STORAGE-2400 Direct Attached Storage unit, allowing you to add additional storage to your Vision
2
Master server. This card is only compatible with specific Vision
2
Master Servers (FG3106-XX), and you can
only install one card per server.
Follow these steps to install the V2-STORAGE-EXT810 External RAID Controller:
1. Power off the V2 Master server.
2. Unlock the cover of the server by flipping up the locking mechanism located on the cover of the server
toward the rear of the device.
3. With the cover unlocked, lift it upward and remove it from the device.
4. On the rear of the server, pull upward on the blue locking tab to unlock the card slots.
5. Install the V2-STORAGE-EXT810 External RAID Controller into one of the available card slots inside
the server.
6. Press down on the blue locking tab to lock the cards back into place.
7. Close the cover on the server and ensure that the cover lock is fastened securely after closing the lid.
FIG. 20 V2-STORAGE-EXT810 External RAID Controller
Before installing the V2-STORAGE-EXT810 External RAID Controller, be sure to
discharge any static electricity from your body by touching a grounded object.
FIG. 21 Front cover locking mechanism
FIG. 22 Locking tab
lift security latch upward to unlock server cover
lift locking tab