Specifications

Installation
27
Vision
2
Operation/Reference Guide
Vision
2
TDS
Vision
2
TDS provides multiple live Digital Video Broadcast (DVB) or MPEG channels over a standard IP
network for up to 150 users for each type of channel. See LAN (RJ-45) Port section on page 17 for information
on wiring cables for the port.
DVB Installation
The following steps show you how to setup a typical DVB configuration for Vision
2
TDS.
1. Connect the power supply to the rear of the Digital TV appliance.
2. Connect an RJ-45 LAN cable to LAN port two on the back of the Digital TV appliance (FIG. 15).
Connect the other end to your Video LAN.
3. Connect an RJ-45 LAN cable to your Video LAN. Connect the other end of the cable to ETHERNET 
10/100 port on the front panel of a digital TV transmitter (FIG. 16).
FIG. 15 Digital TV appliance (rear panel)
To Client-side LAN
To Video LAN
Vision
2
uses typical UTP/STP cabling for RJ-45 connections.
FIG. 16 DTV-TX01-DVB-T Transmitter - Front Panel
Reset
button
Ethernet
10/100 port
The DTV-TX01-DVB-T transmitter (FG1410-01) supports DVB-T (terrestrial) signals.
The DTV-TX02-DVB-S transmitter (FG1410-02) supports DVB-S (satellite) signals.
Each features RF 1/2 OUT output connectors to allow multiple streams for maximum
channel coverage.
The DTV-TX03-US transmitter (FG1410-03) receives incoming ClearQAM or ATSC
digital TV signals. Consult the AMX TDS Operation/Reference Guide for information
on using the various digital TV transmitters available from AMX.