User Guide

ViewStat Installation and Wiring

ViewStat Communicating Thermostat

With remote temperature sensors

Follow the guidelines for placement of the sensors and locate the thermostat indoors where

operating range (see specs) will not be violated (i.e. do not install in a cold garage or hot equipment

room). See the Support Module Installation and Wiring section on page 37 for details.

Removing the Faceplate from the Base

No tools are required to disassemble the thermostat – just use your hands to pull the front panel off

of the base (FIG. 2).

While holding the base of the thermostat, apply pressure to the base of the latch with your thumb

(FIG. 3). Both sides have a latch, but it is easiest to unlatch one side at a time.

FIG. 2 Pulling the front panel off of the base

Loss of internal programs may result from static discharge to thermostat circuit board.

Touch a grounded metal object to discharge any static charge before handling the

circuit board.

FIG. 3 Location of latch on base (one latch on each side)

Press base

here