User`s guide

INDEX
I-2 Blackfin USB-LAN EZ-Extender Manual
L
LAN
device memory map, 1-5
devices, -x, 2-8
power jumper (JP2), 2-5
link jumper (JP3), 2-5
M
Media Access Control (MAC) address, 2-8
Midpan devices, 1-5
MII interface, 1-6
N
notation conventions, -xvi
P
PHY devices, 1-6
power
select jumper (JP1), 2-3
supply, 2-4
Power-over-Ethernet (PoV), -x, 1-5, 2-4
product overview, -x
programmable flags (PFs)
PF10 (ADSP-BF533/61 USB_IRQ),
1-4, 2-7
PF11 (ADSP-BF533/61 USB devices),
1-3
PF6 (ADSP-BF537 USB devices), 1-3
PF7 (ADSP-BF537 USB_IRQ), 1-4, 2-7
PF9 (ADSP-BF533/61 Ethernet IRQ),
1-4
R
reset operation, 1-4
S
schematic of this EZ-Extender, B-1
serial ROM enable switch (SW2.1), 2-8,
2-9
setup, of this EZ-Extender, 1-1
SMSC 91C111 device, 2-5
supervisory reset circuit, 1-4
SW1.1 (address enable) switch, 2-6
SW1.2 (flag enable) switch, 2-7
SW1.3 (USB IRQ enable) switch, 2-7
SW1.4 (test mode enable) switch, 2-8
SW2.1 (serial ROM enable) switch, 2-8,
2-9
SW2.2-2.4 (IOS) switch, 2-9
switches
See also SWx
map of locations, 2-6
system architecture, 2-2
T
test mode enable switch (SW1.4), 2-8
U
USB
device memory map, 1-4
devices, -x
interface, 1-3
IRQ enable switch (SW1.3), 2-7
software documentation, 1-2
USB_IRQ line, 1-4, 2-7