User`s guide

Blackfin USB-LAN EZ-Extender Manual I-1
IINDEX
A
address
bus buffers, 2-6
enable switch (SW1.1), 2-6
ADSP-BF533/37/61 processors
asynchronous memory bank, 1-3, 1-4
programmable flags, 1-3, 1-4, 2-7
ADSP-BF537 EZ-KIT Lite
interfaces, 1-5
power select jumper (JP1), 2-3
architecture, of this EZ-Extender, 2-2
asynchronous memory bank, -x, 1-3, 1-4
B
bill of materials, A-1
block diagram, 2-2
board schematic, B-1
C
configuration, of this EZ-Extender, 1-1
connectors
J1-3 (expansion), 1-2
J2 (PHY devices), 1-6
customer support, -xiii
D
dimensions, of this EZ-Extender, -xi
E
Ethernet
cable, 2-4
devices, -x, 1-4
interface, -x, 1-4
software documentation, 1-3
expansion interface, -x, 1-2
F
flag pins, See programmable flags (PFs)
FLAGS enable switch (SW1.2), 2-7
I
interfaces, 1-1
Ethernet, 1-4
Media Independent Interface (ADSP-BF537
processors), 1-6
Power-over-Ethernet (ADSP-BF537
processors), -x, 1-5, 2-4
USB 2.0, 1-3
IOS switch (SW2.2-2.4), 2-9
IRQ line, 1-4, 2-7
J
J2 connector, 1-6
jumpers
map of locations, 2-3
JP1 (power), 2-3
JP2 (LAN power), 2-5
JP3 (link power), 2-5