User`s guide

Jumper Setting
2-4 Blackfin USB-LAN EZ-Extender Manual
When using an ADSP-BF533 or ADSP-BF561 EZ-KIT Lite, the user
must not place any jumpers on
JP1. Placing a jumper on JP1 can damage
the extender card and/or the EZ-KIT Lite. The user must power the
ADSP-BF533/ADSP-BF561 EZ-KIT Lite and USB-LAN EZ-Extender
with the 7.5V power supply provided with the EZ-KIT Lite.
When using an ADSP-BF537 EZ-KIT Lite without the
Power-over-Ethernet feature, the user must not place any jumpers on JP1.
The user must power both the EZ-KIT Lite and extender with the 7.5V
power supply provided with the EZ-KIT Lite.
When using an ADSP-BF537 EZ-KIT Lite with the Power-over-Ethernet,
the user must place a jumper between JP1 pin 2 and JP1 pin 3. The user
must power both the EZ-KIT Lite and USB-LAN EZ-Extender with the
CAT5E Ethernet cable, which provides power over the signal pairs. The
Ethernet cable must be plugged into the Ethernet connector of the
ADSP-BF537 EZ-KIT Lite, but not the USB-LAN EZ-Extender. The
7.5V power supply provided with the EZ-KIT Lite should not be used.
For an overview of the Power-over-Ethernet interface, refer to
“Power-Over-Ethernet” on page 1-5.
Table 2-1. JP1 Settings
Source of 5V Power JP1 Setting
EZ-KIT Lite power No jumpers (default)
USB test mode (do not use) JP1.1 and JP1.2
Power-over-Ethernet JP1.2 and JP1.3