User manual
32
Introduction
32
Introduction
Placement of your Wireless Networking Hardware for 
Optimal Performance
Your wireless connection will be stronger the closer your computer 
is to your Wireless Router (or Access Point). Typical indoor operating 
range for your wireless devices is between 100 and 200 feet. In the 
same way, your wireless connection and performance will degrade 
somewhat as the distance between your Wireless Router (or Access 
Point) and connected devices increases. This may or may not be 
noticeable to you. As you move further from your Wireless Router 
or Access Point, connection speed may decrease. Factors that can 
weaken signals simply by getting in the way of your network’s radio 
waves are metal appliances or obstructions, and walls. 
If you have concerns about your network’s performance that might be 
related to range or obstruction factors, try moving the computer to a 
position between five and ten feet from the Wireless Router, in order 
to see if distance is the problem. If difficulties persist even at close 
range, please contact Belkin Technical Support. 
IMPORTANT FACTORS FOR PLACEMENT AND SETUP
Note: While some of the items listed below can affect network 
performance, they will not prohibit your wireless network from 
functioning; if you are concerned that your network is not operating at 
its maximum effectiveness, this checklist may help.
1.   Placement of your Wireless Networking Hardware
Place your Wireless Router (or Access Point), the central connection 
point of your network, as close as possible to the center of your 
wireless network devices.
To achieve the best wireless network coverage for your “wireless 
clients” (i.e., computers enabled by Belkin Wireless Notebook Network 
Cards, Wireless Desktop Network Cards, and Wireless USB Adapters): 
•   Ensure that your Wireless Router (or Access Point) networking 
antennas are parallel to each other, and are positioned vertically 
(toward the ceiling). If your Wireless Router (or Access Point) 
itself is positioned vertically, point the antennas as much as 
possible in an upward direction. 










