Specifications

6 | ni.com | NI cRIO-9030 Getting Started Guide
Installing C Series I/O Modules in the Chassis
Complete the following steps to install a C Series I/O module in the chassis.
1. Ensure no I/O-side power is connected to the I/O module. If the system is in a nonhazardous
location, the chassis can be powered on when you install I/O modules.
2. Align the I/O module with an I/O module slot in the chassis as shown in Figure 2. The
module slots are labeled 1 to 4, left to right.
Figure 2. Installing an I/O Module in the cRIO-9030
3. Squeeze the latches and insert the I/O module into the module slot.
4. Press firmly on the connector side of the I/O module until the latches lock the I/O module
into place.
5. Repeat these steps to install additional I/O modules.
Removing I/O Modules from the Chassis
Complete the following steps to remove a C Series I/O module from the chassis.
1. Ensure no I/O-side power is connected to the I/O module. If the system is in a nonhazardous
location, the chassis can be powered on when you remove I/O modules.
2. Squeeze the latches on both sides of the module and pull the module out of the chassis.
1 Insertion Groove 2Latch
NI cRIO-9030
1
2