Specifications

Configuration - Status Page
40
UDM-1604C 4x16 Multi-Format Distribution Hub
4. Select either the Port or Device radio button to specify whether this button on the remote should be
associated with the Port (display device) or an actual Device (e.g. a DVD player added to the system
as a device) when it is pushed.
5. The Endeleo Receiver will now accept the relevant command from the RC02 remote (i.e. Key 2 on
the remote will "Play" the Device (FIG. 37). .
Passthrough Mode (Inputs A-D, TVM Inputs 1-4)
Devices can also be placed into Passthrough Mode. Passthrough Mode allows an Endeleo TVM remote
control to be used to control TV channels being viewed through the UDM-1604C, or devices connected
to the UDM-1604C (e.g. a DVD player). Passthrough Mode is available for Inputs A-D and for TVM
inputs 1-4, as shown in FIG. 38:.
The following steps must be taken for Passthrough Mode to function correctly:
1. The Device must be added to the system as an Input.
2. IR emitter (on the correct IR port) at the rear of the UDM-1604C must be connected to the device.
3. The Device must be added to the system as a Device and be assigned its learned protocol.
4. The Device’s Port must be configured for Passthrough Mode.
Ensure the correct key on the Endeleo Remote corresponds with the correct
command.
FIG. 37 Port Configuration options for Port 1 (Key 2 set to "Play")
FIG. 38 User Control options (for Port 1) - Passthrough Mode options