Specifications

Configuration - Status Page
31
UDM-1604C 4x16 Multi-Format Distribution Hub
Video Compensation (UDM-RX01/RX02)
Video at the Receive end can be compensated using three main methods;
 Using the WebConsole to compensate each port individually in the Status option (see the
Video Compensation section on page 29).
 Using the Endeleo Remote Control to compensate video (see the Compensating Video Via the
UDM-RC10 Remote Control section on page 31).
 Using a hyper terminal session via the serial connector on the UDM-RX02 (especially
effective when using long runs). See the Advanced Administration section on page 93 for
details.
Compensating Video Via the UDM-RC10 Remote Control
Video can also be compensated using the Endeleo UDM-RC10 IR Engineering Remote Control
(FIG. 26).
1. Ensure the IR03 Endeleo External IR Receiver Module (FG-IR03) is attached to the UDM-RX02 at
the IRRX port (FIG. 26).
2. To enter compensation mode, push the ESC and B buttons on the remote control.
FIG. 25 Port Configuration options - "Enable advanced options" selected in the Setup page and "Advanced" selected
Video compensation settings can also be configured via hyper terminal session. See
the Advanced Administration section on page 93 for details.
FIG. 26 UDM-RX02 with IR03 IR Receiver Module
IR RX port
UDM-RX02
Amber LED indicates that UDM-RX02 is in Compensation mode
IR03 IR Receiver Module (FG-IR03)