Specifications

Advanced Administration
100
UDM-1604C 4x16 Multi-Format Distribution Hub
The table below describes typical values returned when using the ? command on an input port.
User Outputs
1.
To view a port’s properties, type a question mark before the port number.
Ensure there is a space between the question mark and the number. (FIG. 126)
For example ? 1 will display Port 1 properties.
2. Push Enter once the command has been entered.
3. The table below describes typical values returned when using the ? command on a Hub port.
Copying IR/Serial Tables
To copy the IR/Serial tables from a UDM Hub:
1. Run your TFTP client. If using the Windows client, move to step 2.
2. Create a folder on the C: drive named Endeleo.
3. Open a command prompt (Start, Run, type "cmd" <enter>) and change it to the C:\Endeleo
directory.
4. Connect the serial cable (RJ12 to DB9) that is supplied with the UDM Hub.
Multi-Format Input Configuration
Value Description
129 Input A
00.06.00 Input Controller Version
XGA Extended Graphics Array
1024x768 Screen Resolution
799 Vertical lines on screen
H+ Horizontal polarity (+/-)
V+ Vertical polarity (+/-)
FIG. 126
Querying a port
Value Description
Port 1 Port number on UDM Hub
01.11.00 Port Controller version
Clock Master 8406 Master (version)
Disconnected / Connected Connected to RX
Port Power On or Off
Port Number Checksum Port in Master or Target Hub
Windows XP Pro has a built in TFTP client program. If you are using another
operating system, or have an alternate TFTP client, follow the directions of your OS
and install TFTP client if necessary. Consult with AMX Technical Support as to the
appropriate client for your OS.