Specifications

Advanced Administration

UDM-1604C 4x16 Multi-Format Distribution Hub

Backend Commands

In case of human error the Command Line can be used to perform several Administrative tasks on the

multi format video Hub.

Changing the Login Password

Create a hyperterminal session with the UDM Hub using default serial connections.

2. To change the password enter the original password and new password separated by a colon at the

For Example type in admin:endeleo at the login prompt, to change the password from admin to

endeleo.

3. Reset the Hub. A power off then on is now required.

Obtaining the Hub’s IP Address Via the Command Line

Type i at the command prompt. (FIG. 124) Push enter.

Checking Port Details

Port details (resolution, port firmware) can be checked via the command line also.

Multi Format Inputs

The multi format inputs located at the rear of the Hub are numbered 129 through to 132 for

administrative purposes.

1. To check the input port configuration, type in the following – a question mark followed by the Input

Number (129, 130, 131 or 132):

Example: ? 129

2. Push Enter.

3. The following information will be displayed (FIG. 125);

FIG. 124 Issuing the i command

Multi format inputs

Input Input Number

A 129

B 130

C 131

D 132

FIG. 125

Querying a multi format input port