User manual
Table Of Contents
- 2711-UM014G-EN-P, PanelView Standard Operator Terminals User Manual
- Important User Information
- Summary of Changes
- Table of Contents
- Preface
- 1 - Terminal Overview
- Chapter Objectives
- Intended Uses
- Terminal Types
- PanelView 300 Micro Terminal Features
- PanelView 300 Terminal Features
- PanelView 550 Terminal Features
- PanelView 600 Terminal Features
- PanelView 900/1000 Terminal Features
- PanelView 1400 Terminal Features
- Applications
- Configuration Mode Menu
- Terminal Messages
- Printing
- Alarm List
- Accessories
- Replacement Parts
- 2 - Applying Power and Resetting Terminal
- 3 - Configuring the Terminal
- 4 - Using a Memory Card
- 5 - Running Applications
- Chapter Objectives
- Application Information
- Important Information for PanelView 300 Micro Terminal Operations
- Screen Security
- Push Button Operation
- Control Lists
- ASCII Entry Controls
- Screen Selectors
- List Indicators
- Multistate Indicators
- Bar Graph Displays
- Analog Gauges
- Numeric Data Displays
- Message Displays
- Time or Date
- Printing
- Alarms
- 6 - Installing the PV300 Micro Terminal
- 7 - Installing the PV300 Terminal
- 8 - Installing the PV550 Terminal
- 9 - Installing the PV600 Terminal
- 10 - Installing the PV900/1000 Terminals
- 11 - Installing the PV1400 Terminal
- 12 - Terminal Connections
- Chapter Objectives
- Wiring and Safety Guidelines
- Cable Charts
- Remote I/O Terminal Connections
- DH+ Terminal Connections
- DH-485 Terminal Connections
- RS-232 (DH-485) Terminal Connections
- RS-232 (DF1) Terminal Connections
- ControlNet Connections
- DeviceNet Network Terminal Connections
- EtherNet/IP Connections
- PanelView 300 Micro Terminal Connections
- Connecting a Computer or Printer to the Terminal
- 13 - Troubleshooting and Maintenance
- A - Specifications
- B - Messages, Codes and Self-test Numbers
- C - European Union Directive Compliance
- Glossary
- Index
- Back Cover
Publication 2711-UM014G-EN-P - September 2008 167
Installing the PV900/1000 Terminals Chapter 10
Install the
PV900/PV1000 Terminals in
a Panel
Follow these steps to install the PV900/PV1000 terminal in a panel.
1. Cut an opening in the panel by using the panel cutout template
provided with the terminal and remove any sharp edges or
burrs.
2. Make sure the terminal sealing gasket is properly positioned on
the terminal, particularly around the mounting studs as shown.
This gasket forms a compression type seal. Do not use sealing
compounds.
Although the keypad legend strip can be installed any time, we
recommend that you install it after the terminal is installed.
3. Place the terminal in the panel cutout.
ATTENTION
• Disconnect all electrical power from the panel before making the
cutout.
• Make sure the area around the panel cutout is clear.
• Do not allow metal cuttings to enter any components that may
already be installed in the panel.
• Failure to follow this warning may result in personal injury or damage
to the panel components.
Sealing Gasket