Installation guide

Programming AMX Controllers for a Kaleidescape System
Page 24
4. Click on the Settings button for the player.
Figure 5: Component Settings button
5. Select the CONTROL tab from the Settings page.
6. Select the Control Protocol Device ID (None, 02 through 99) from the drop-
down menu.
Select None only if command routing is NOT used for this device as shown
in the following figure.
Figure 6: Control tab
7. Click OK. The component does not have to be rebooted.
Configuring the Kaleidescape Multiple Panel Include file when using CPDID addressing
In the example illustrated in Figure 7, an AMX controller is connected to a 1U
Server either by Ethernet or the RS-232 control port. Unique CPDIDs are assigned
(in the installer pages of the browser interface) to four M500 Players and one Music
Player. The Music Player has four music zones controlled independently by adding
Zone IDs. Because the 1U Server connected to the AMX controller is the local
device, the server uses the default CPDID None. The second 1U Server does not
have to be controlled, so the CPDID is left at the default CPDID None.
After CPDIDs for M500 Players have been defined, use the ID command to associate
the CPDIDs with the corresponding virtual devices.
Select None
Click on Settings