User Guide

Firmware Pages and Descriptions
65
NXP-TPI/4 NetLinx Touch Panel Interface
The elements of the RGB Adjustment page are described in the table below:
RGB Adjustment Page Elements
Back: Saves the changes and returns you to the previously active touch panel page.
Connection Status icon: This visual display of the connection status allows the user to have a current
update of the TPI/4’s connection status regardless of what page is currently
active.
• A Lock only appears on the icon if the TPI/4 has established a connection with
a currently secured target Master (requiring a username and password).
Settings: • The Default Settings button sets the RGB settings to their default values
(indicated in this table).
• The Undo Changes button disregards any changes made on the page since
the last settings were saved.
• The Save Settings button saves any changes made to the RGB Adjustment
page.
• The Sync on Green button sets the TP4-RGB card to search for the sync
signal on Green signal.
Version: Displays the firmware version currently on the internal TP4-RGB card.
Status: Displays the input signal properties of the signal routed through the internal
TP4-RGB card (H-pixel x V-pixel @ Hz). An example is: 1280x1024@75Hz.
• This is the property of the incoming signal and not the resolution of the TPI/4.
Phase: Use the UP/DN buttons to alter the RGB tracking/signal level.
• Range = 0 - 31, default = 0.
H Position: Use the UP/DN buttons to alter the horizontal position level.
• Range = 0 - 255, default = 0.
H Size: Use the UP/DN buttons to alter the horizontal size level.
• Range = 0 - 255, default = 0.
V Position: Use the UP/DN buttons to alter the vertical position level.
• Range = 0 - 255, default = 0.
All Brightness: Use the UP/DN buttons to alter the overall brightness level of the selected video
input (card).
• Range = 0 - 255.
Red Brightness Use the UP/DN buttons to alter the brightness of the red color value.
• Range = 0 - 255, default = 127.
• For more accurate control, you will have to go into the Full Screen Edit Mode
described in the following section.
Green Brightness Use the UP/DN buttons to alter the brightness of the green color value.
• Range = 0 - 255, default = 127.
• For more accurate control, you will have to go into the Full Screen Edit Mode
described in the following section.
Blue Brightness Use the UP/DN buttons to alter the brightness of the blue color value.
• Range = 0 - 255, default = 127.
• For more accurate control, you will have to go into the Full Screen Edit Mode
described in the following section.