User Guide

Firmware Pages and Descriptions
64
NXP-TPI/4 NetLinx Touch Panel Interface
Video Adjustment - RGB Setup
The RGB Setup page (FIG. 47) (accessed by pressing the Video Adjustment button on the Setup page and
then selecting a SLOT # from the option bar which contains a TP4-RGB card) sets the RGB properties of
the incoming signal. These slots are labeled at the rear of the unit.
Video Adjustment Page Elements (Cont.)
Format: Allows you to press this blue field and cycle through a choice of available video
formats (NTSC, PAL, SECAM, or Auto detect).
• Default = Auto.
Input: Allows you to cycle through a choice of available video inputs
(either Composite or S-Video).
• Default = Composite.
Brightness: Use the UP/DN buttons to alter the brightness level of the incoming signal.
• Range = 0 - 255, default = 128.
Contrast: Use the UP/DN buttons to alter the contrast level of the incoming signal.
• Range = 0 - 255, default = 128.
Saturation: Use the UP/DN buttons to alter the color saturation level of the incoming signal.
• Range = 0 - 255, default = 128.
Hue: Use the UP/DN buttons to alter the hue level of the incoming signal.
• Range = 0 - 255, default = 128.
If the TPI/4 is powered Off, any preset TPD4 Video pages must be reset if you are
using an S-Video input.
By default, the Input is set to Composite. If the video pages appear blank upon
restart of the unit, simply toggle the Input setting to S-Video.
FIG. 47 RGB Adjustment page (showing the default values)
Incoming signal shown in the background
Once you are done making your
adjustments, click SAVE SETTINGS.
Firmware version of TP4-RGB card
Pressing this area activates the
Full Screen Edit mode
Output resolution