User Guide

Installation

NXP-TPI/4 NetLinx Touch Panel Interface

ICSNet Port: Connections and Wiring

The following tables show the signal and pinout/pairing information used for ICSNet RJ-45 data

connections. ICSNet uses a standard CAT5 Ethernet cable to provide communication between the

NXP-TPI/4 touch panel interface and the NetLinx Master.

Ethernet/RJ-45 Port: Connections/Wiring

FIG. 11 describes the blink activity for the Ethernet 10/100 Base-T RJ-45 connector and cable. The

Ethernet cable is connected to the rear of the TPI/4.

ICSNet RJ-45 Signals

Pin Signal-Master Signal-TPI/4

1 TX + RX +

2 TX - RX -

3N/A N/A

4GND GND

5N/A N/A

6N/A N/A

7 RX + TX +

8 RX - TX -

RJ-45 Pinout Information (EIA/TIA 568 B)

Pin Wire Color Polarity Function

1 Orange/White + Transmit

2 Orange - Transmit

3 Green/White - Mic

4 Blue - Ground

5 White/Blue + 12 VDC

6 Green + Mic

7 White/Brown + Receive

8 Brown - Receive

FIG. 11

Ethernet connector (showing communication and connection LEDs)

TIA 568B

1 2 3 4 5 6 7 8

RJ-45 connector - pin configurations

(female) (male)

ETHERNET

10/100

A L

A - Activity LED (yellow)

lights when receiving or

transmitting Ethernet

data packets

L - Link LED (green) lights when

the Ethernet cables are connected

and terminated correctly.