User Guide

Installation

NXP-TPI/4 NetLinx Touch Panel Interface

The following table lists the DB9 connector pinouts.

VGA Port: Connections and Wiring

Using the VGA OUT HD-15 high-density connector

Connect the VGA source equipment HD-15 (male) connector (from the touch device) to the

VGA OUT HD-15 high-density connector (female) on the rear panel of the TPI/4. The following table

below lists the VGA OUT HD-15 connector pinouts.

DB9 (female to female) Null Modem Pinouts

DB9 A Signal DB9 A DB9 B DB9 B Signal

Receive Data (RXD) 2 3 TXD

Transmit Data (TXD) 3 2 RXD

Data Terminal Ready

(DTR)

4 6 + 1 DSR + Carrier Detect

System Ground (GND) 5 5 GND

Data Set Ready (DSR)

+ Carrier Detect

6 +1 4 DTR

Request to Send (RTS) 7 8 CTS

Clear to Send (CTS) 8 7 RTS

VGA IN HD-15 Connector Pinouts

Pin Signal Function

1 Red Red signals

2 Green Green signals

3 Blue Blue signals

4 N/A Not used

5 GND Signal Ground

6 RAGND Red analog ground

7 GAGND Green analog ground

8 BAGND Blue analog ground

9 N/A Not used

10 SAGND Synchronization analog ground

11 N/A Not used

12 N/A Not used

13 HSYNC Horizontal synchronization signal

14 VSYNC Vertical synchronization signal

15 N/A Not used

DB9 female

connector

side A

DB9 female

connector

side B

VGA HD-15 (male)

connector