User Guide

Installation

NXP-TPI/4 NetLinx Touch Panel Interface

Step 3: Upgrading the internal EXM memory module

With the housing removed, locate the EXM memory module on the main board. Refer to FIG. 6 for

location information.

2. Discharge any static electricity from your body by touching a grounded metal object or the

grounding bolt shown in FIG. 4 on page 9.

3. Firmly grip the metallic braces (located on each side of the memory module) and pull them both

outwards until the previous module pops-up.

4. Firmly grasp the existing memory module and pull it out at a 45° angle away from the connector

location on the main board.

5. Remove the memory module upgrade from the anti-static bag.

6. Firmly grasp the new memory module (from the edges) and insert the pins (at a 45° angle) into the

opening on the connector.

FIG. 6 Location of the memory modules

FIG. 7 Removing the memory module

Compact Flash card

Extended memory

Battery

Housing screws

EMI gasket

location

module

Input card

connectors

Pull tabs outward

Module flips upwards

Pull memory

out at a 45° angle

Connector

Alignment

groove

Metallic

braces