User manual

Installing the Switch

NXA-ENET24 Hardware Installation Guide

Connecting to a Power Source

To connect a switch to a power source:

1. Insert the power cable plug directly into the AC receptacle located at the back of the switch.

2. Plug the other end of the cable into a grounded, 3-pin socket, AC power source.

3. Check the front-panel LEDs as the device is powered on to be sure the PWR LED is lit. If not, check

that the power cable is correctly plugged in.

FIG. 19 Power Receptacle

100-240V~ 50-60Hz 7.5A

Power Socket

For international use, you may need to change the AC line cord. You must use a line

cord set that has been approved for the receptacle type in your country.