User manual

Introduction
6
NXA-ENET24 Hardware Installation Guide
Mode PoE/Link Button
The Mode PoE/Link button is located on the front panel.
The Mode PoE/Link button is used to toggle between the two port status LED display modes (See “Port
and System Status LEDs” on page 3.). Pressing this button changes from one display mode to the other.
The default display mode is Link/Act mode.
Power Supply Receptacle
The standard power receptacle is for the AC power cord. It is located on the rear panel of the switch.
FIG. 5 Mode Selection
FIG. 6 Power Supply Receptacle
Link/Act
PoE
25
26
PWR
Diag
Stacking
Mode
PoE/Link
Mode Select Button
100-240V~ 50-60Hz 7.5A
Power Socket