Specifications

Accessing Servers
50
Vision
2
Operation/Reference Guide
8. Access the server’s Vision
2
application. See the Accessing the Server section on page 48 for more
information.
9. Change the Master Server Name to the Master R710 server’s name (FIG. 49).
10. Click Apply, and restart the application. You can now control this server via the Main Master server.
You have now successfully added a new server. On the remote server, you must change the Master Server
Name in the Vision
2
application to the Master Server and restart the application.
FIG. 49 Vision
2
Server application
Change the Master server name
If an incorrect server name is entered the system will attempt the connection for 30
seconds and then if unsuccessful the following error message will appear. Click OK,
and click Add New Server again.