User's Manual

Installing Wall-Mount (MXD) Panels
65
Modero X® Series Touch Panels - Installation & Hardware Reference Manual
NOTE: If you see a gap between the panel and the Backbox or feel any binding while locking down the panel, stop immediately
and verify that no cables or other items are in the way. Do not force the panel into position, as this can cause damage to the
touch screen or the panel electronics.
10. Reconnect the terminal Ethernet and USB to their respective locations on either the Ethernet port or NetLinx Master.
Power via PoE
Power for the MXD-430 is supplied via PoE (Power Over Ethernet), utilizing an AMX-certified, capacitive touch-compliant PoE
injector such as the PS-POE-AT High Power PoE Injector (FG423-81) or other approved AMX PoE power source. The incoming
Ethernet cable should be connected to the RJ45 port on the device.
Uninstalling the MXD-430
The MXD-430 is held in place to the Backbox via latch hooks and a clip on the Backbox (FIG. 46), securing it to the mounting
surface. In certain circumstances, such as firmware updates or other maintenance that requires accessing the device’s USB port,
the device may need to be removed from the Backbox.
The clip that locks down the MXD-430’s top edge may be unlatched in order to remove the device from the mounting surface.
Removing an MXD-430 from Its Backbox
1. The MXD-430 has three rows of ventilation holes along the molding (FIG. 48):
FIG. 58
Installing the MXD-430
Mounting Surface
Backbox
Latch Hooks
Snap