Specifications

Installation

RADIA Lighting Control System

Each contact closure connection (1 through 8) is pre-programmed with a default preset. The following table

shows the default presets for each contact closure.

Default Mode (Reset)

Default mode is resetting the AMX Lighting module values to zero and the module then begins to function on

the values you previously programmed into the module. If you experience problems after installing a lighting

system, you may need to reset the controller module to default mode. Then, you should be able to determine if

there is a problem with the connections, programming, and/or dimming.

To reset a AMX Lighting controller to default mode:

1. Power off the AMX Lighting enclosure at the circuit breaker panel.

2. Disconnect all AxLink and PROlink cables from the controller module.

3. Connect a jumper to the dry contact closures 1 through 8 and to ground as shown in FIG. 22.

4. Power up the controller enclosure and wait for the controller's green status LED to go off after

approximately 1 minute.

5. Using a non-conductive rod or wooden one-quarter inch dowel rod (approximately 12" long) press the

RESET button located on the controller module circuit board.

6. At the breaker panel, remove power from the controller enclosure.

7. Remove the jumpers from the dry contact closure connector.

8. Reconnect the AxLink and PROlink connections.

9. Power up the controller enclosure.

Dry closure default presets

Contact closure Default function

1 Channel 1 at 100% in 1 second*

2 Channel 2 at 100% in 1 second*

3 Channel 3 at 100% in 1 second*

4 Channel 4 at 100% in 1 second*

5 Channel 5 at 100% in 1 second*

6 Channel 6 at 100% in 1 second*

7 Pack on (channels 1-6)*

8 Pack off (channels 1-6)*

*All other channels are undefined.

FIG. 22

9-pin dry closure connector set to default mode

1 2 3 4

7 8