User Guide

AMX Corporation reserves the right to alter specifications without notice at any time.
For full warranty information, refer to the AMX Instruction Manual(s) associated with your Product(s).
043-019-2194 8/02 ©2002 AMX Corporation. All rights reserved.
The AMX logo is a trademark of AMX Corporation. AMX reserves the right to alter specifications without notice at any time.
3000 research drive, richardson, TX 75082 USA • 469.624.8000 • 800.222.0193 • fax [phone] • technical support 800.932.6993
Line-in Connections:
Connecting Dry Closures:
Use the 8 (+ common) dry closures with a WPD8 eight-button wall panel.
Each contact closure connection (1 - 8) is pre-programmed with a default
preset. The table below shows the default presets for each contact
closure.
Setting AXlink and PROlink Address Numbers:
Lighting Application Drawings
FIG. 5 Line-in Connections
FIG. 6 Dry closures connection
Dual 20 A Inputs
Bridged 20 A Input
20 A
Using two feeds for line 1 and line 2 provides
two, 20 A inputs.
Bridging line 1 and line 2 provides a single
20 A input.
1
2
3
4
5
6
78
COM
Each contact (1 - 8) is pre-
programmed with a default preset.
Refer to the AMX Lighting Control
System instruction manual for
details on dry closure default presets
and recording new presets.
Dry Closure Default Presets
Contact Closure Default Function
1 Channel 1 at 100% in 1 second
2 Channel 2 at 100% in 1 second
3 Channel 3 at 100% in 1 second
4 Channel 4 at 100% in 1 second
5 Channel 5 at 100% in 1 second
6 Channel 6 at 100% in 1 second
7 Pack on (channels 1-6)
8 Pack off (channels 1-6
All other channels are undefined.
FIG. 7 Setting AXlink and PROlink address numbers
AXlink Address PROlink Address
Te st
Set the AXlink address number
(1-255) for the RDD-DM4. This
number must match the device
number in your Axcess program.
Use the PROlink DIP switch to set
the PROlink address number for the
RDD-DM4 (1-10).
Pin 8 on the PROlink DIP switch is
a test switch that turns all circuits on
to full.
FIG. 8 Method A
FIG. 9 Method B
Method A
120 VAC 1Ø /
Single-phase, four load
Method B
Typical 120 VAC
Single-pahse, four-wire
dual-feed