User`s manual

8
Quick-start Guide (LumaWatt System Software)
Operational Setup
Look for any LED activity on the connector side of the
NETGEAR
®
switch to verify that power is on. Press
and release the momentary power button located on
the right side of the LumaWatt energy
management server to power it on. The power
button should illuminate with an LED if power is
turned on. Allow approximately four minutes for the
LumaWatt energy management server to complete
its power up tasks before continuing. Connect an
Ethernet cable from a free port (port 5 thru 8) on the
NETGEAR
®
switch to the Ethernet port on a laptop
or desktop PC. An internet browser must be installed
on this setup computer to communicate with the
LumaWatt energy management server. The user must
have administrator privileges on this computer. If this
computer has a wireless network adapter present it
must be disabled here before continuing.
STEP 1 (FIG. 1)
To congure the PC to connect to the LumaWatt
energy management server it is necessary to change
the PCs IP address as follows: Select Start – Control
Panel to open control panel as shown.
STEP 2 (FIG. 2)
Select Network and Sharing Center and then Local
Area Connection.
STEP 3 and 4 (FIG. 3 - 4)
Select Properties and then right click on Internet
Protocol Version 4 (TCP/IPv4) to highlight it.
STEP 5 (FIG. 5)
Click Properties and select Use the following IP
address. Fill in the IP addresses as shown below
and click OK. Click OK on the Local Area
Connection Properties and Close on Local Area
Connection Status. The PC is now congured to
connect to the LumaWatt energy management server.
STEP 6 (FIG. 6 - Launch Web Browser)
Type in the following address in the URL box and hit
enter: https://169.254.0.1/ems. You will be presented
with a warning stating that the site’s security certicate
is not trusted. Click Proceed Anyway to go to the
systems login page. If the login page displays asking
for the Username and Password you have
successfully installed the system. To continue system
setup and conguration please refer to the LumaWatt
Wireless Lighting Control User’s Manual.
FIG. 1
FIG. 3
FIG. 5 FIG. 6
FIG. 2
FIG. 4