User Guide

AMX Lighting - Enclosure Worksheet Guide

 Volt s: Use this cell to enter the voltage of the load connected to the dimmer. This is

important because some local electrical codes do not allow mixing of voltages in a single

enclosure. Local codes may also require use of a separate container for each voltage device

used on the premises. Some dimming modules are phase dependent, and mixed voltages will

cause poor dimming performance when the controller is out of phase with the supply voltage

to the dimmer. The voltage of the controller chosen often determines what voltages can be

specified in the dimmers.

VOLTS uses a drop-down menu containing the voltage choices

listed below:

 Load (W): Use this cell to specify the load rating in Watts (default) or Amps. Dimmers are

generally specified in Watts, whereas switches are specified in Amps. Data in this cell cis used

to determine the total Watts per dimmer or integrated dimmer (DM series). This column can

also help determine if the load ratings of the dimmer or switch are overloaded or undersized.

AXlink

DEVICE # uses a text field that allows (5) characters:

Rows and Cells

The following describes the various row information and fields. These are the available choices to enter

data into the worksheet cells.

 SLOTS: Each slot is made up of three rows and can contain three dimmers or switches. Slots

can have one, two, or three dimmers (or contain no dimmers at all). Slot can contain Radia

accessories such as power supplies or a choke module. When no dimmers or accessories are

installed, a blank plate (RDA-EFP) must be used/specified.

 DIP Switches: Set these according to what you specified in the AXlink Device # and

PROlink

PACK # cells. These are binary state numbers using On or Off to indicate the state of

the DIP switch setting. The AXlink switches accommodate an 8-bit number from 0 to 255.

The first four PROlink switches accommodate a 4-bit number from 0 to 10. The 8th DIP

switch on PROlink is for the Test Mode and is defaulted in the Off position. DIP Switch uses

a drop-down menu containing the switch choices listed below:

 Controller Cards: Up to three controllers can be located in a surface mounted enclosure.

The ENC8W can have four Radia control cards. I would then use two distinct Worksheets.

• blank

• 120

• 240

• 277

Text field

•ON

•OFF