Setup guide

Connecting the Media Server Cables
23
Connecting to a 2-Gb MEDIASwitch
Use the following procedure to correctly connect an optical SFP and
optical cable to a 2-Gb MEDIASwitch.
To connect an optical cable to the 2-Gb MEDIASwitch:
1. Locate the optical SFP in the Media Server kit.
2. Route the optical cable from the Media Server to the MEDIASwitch, if
it has not been installed already.
3. Position the optical SFP in front of a MEDIASwitch port (see
Figure 4). Make sure the optical cable connector is facing away from
the MEDIASwitch.
Figure 4 Installing an SFP Connector
n
You can install the SFP while the MEDIASwitch is turned on.
4. Slide the optical SFP into the MEDIASwitch port. You should hear a
click when the optical SFP is seated in the port.
5. Remove the protective covers from the optical cable connector on the
optical cable.
6. Remove the protective cover from the optical SFP in the
MEDIASwitch.
3
2
1
4
5
6
7
8
9
1
0
1
1
12
13
14
15
16
100
Act/Col
M
G
M
T
E
N
E
T
0550201A_BK.book Page 23 Thursday, January 9, 2003 10:44 AM