Setup guide

1-9
Connecting the Media Server Cables
Connecting to a 2-Gb MEDIASwitch
To connect an optical cable to the 2-Gb MEDIASwitch:
1. Locate the SFP in the Media Server kit.
2. Route the cable from the Media Server to the MEDIASwitch, if it
has not already been installed.
3. Position the SFP in front of a MEDIASwitch port (see Figure 1-4).
Make sure the optical connector is facing away from the
MEDIASwitch.
Figure 1-4 Installing a SFP
n
You can install the SFP while the MEDIASwitch is turned on.
4. Slide the SFP into the MEDIASwitch port. You should hear a click
when the SFP is seated in the port.
5. Remove the protective covers from the optical connector on the
optical cable.
6. Remove the protective cover from the SFP in the MEDIASwitch.
RS232
1
2
3
4
5
6
7
8
100
Act/Col
MGMT
0525701A_BK.book Page 9 Tuesday, April 16, 2002 9:25 AM