User Guide

Appendix B: AMX Lighting Curves

MX Lighting PROlink/AXlink Programming

FIG. 38 shows the output voltage of Curve B applied to the RAD-VDR module. The turn on

voltage is 2VDC and rises to 10VDC. This curve can be used with 0-10 VDC dimming ballasts.

FIG. 39 shows the output voltage of a RAD-MC120 dimmer. This curve starts at the low end at

about 20 volts and gently rises to only 113 volts. This curve reduces dimming range by about 20%.

! Relay turn on level = 1%

! Dimming Range = 20 - 115 VAC.

FIG. 40 shows the DC output voltage of Curve C applied to the RAD-VDR module. It starts at

2VDC and rises to 10VDC. This curve can be used with 0-10 VDC dimming ballasts.

FIG. 37 Curve B Voltage output in Volts RMS

FIG. 38 Curve B Voltage output in Volts DC

FIG. 39 Curve C Voltage output in Volts RMS