User Guide

Appendix B: AMX Lighting Curves

AMX Lighting PROlink/AXlink Programming

FIG. 24 shows the output voltage of the RAD-VDR module. Curve 4 is primarily used for control

of Prescolite Intelect Ballast, using the RAD-VDR module. Its range is from 1 to 12 VDC.

FIG. 25 shows the output voltage of a RAD-MC120 dimmer. It quickly dims the high end and

extends the mid-range dimming control with a cut-off at 18 volts. This curve can be useful with two

wire dimmable fluorescent ballasts.

! Relay turn on level = 1%

! Dimming Range = 16 - 120 VAC.

FIG. 26 shows the output voltage of Curve 5 applied to the RAD-VDR module. It turns on to about

2 volts and rises to 12 VDC. There is a large increase in output above 98%.

FIG. 24 Curve 4 Voltage output in volts DC

FIG. 25 Curve 5 Voltage output in Volts RMS

FIG. 26 Curve 5 Voltage output in volts DC