User Guide

Appendix B: AMX Lighting Curves

MX Lighting PROlink/AXlink Programming

FIG. 21 shows the output voltage of a RAD-MC120 dimmer. It has a smooth taper and a cut off

point of 25 volts. This curve will shrink incandescent dimming range 25%.

! Relay turn on level = 1%

! Dimming Range = 30 - 115 VAC.

FIG. 22 shows the output voltage of the RAD-VDR module. The voltage range is from 2.6 to 9.3

VDC when attached to test ballast. This curve is primarily used with Advance Mark VII ballast

using the RAD-VDR module.

FIG. 23 shows the output voltage of a RAD-MC120 dimmer. There is a noticeable gap at the low

end. Curve 4 is a smooth fade until 15%, then it rolls off sharply.

! Relay turn on level = 1%

! Dimming Range = 0 - 120 VAC.

FIG. 21 Curve 3 voltage output in volts RMS

FIG. 22 Curve 3 output in volts DC

FIG. 23 Curve 4 Voltage output in Volts RMS