User Guide

Product Information

PRO-DP8 Decor 8-Button Wall Panel

Product Information

The PRO-DP8 is an 8-button wall panel designed to directly control AMX Radia Lighting™

systems. It is a PROlink panel that gets its power and data from a Radia Lighting Controller

attached to the dimmer control cards. PROlink panels do not have addresses and can be chained

together with minimal setup requirements. Each wall panel provides individual control of up to 12

channels (zones) via up to 3 dimmer control cards connected to the PROlink bus.

The Decor style PRO-DP8 can store/recall Preset light levels (Presets), raise/lower light levels to

create scenes, and turn lights on/off. It fits in a single-gang wall box and is connected using a low-

voltage 4-wire cable. PROlink panels are connected directly to the dimmer controllers and work

independently from AXlink or AMX Central Controllers. It comes with a standard overlay that can

be custom engraved for special uses, and allows the removal of selected buttons if desired. The

ability to recall different Presets from different panels is done via rear panel DIP switch settings.

Specifications

Dimensions (HWD) 4.68" x 2.93" x 1.72" (118.7 mm x 74.4 mm x 43.6 mm)

Voltage 12 VDC; 50 mA maximum per panel

Weight 3.17 oz (89.86 g)

Connector PROlink 4-pin data/power captive-wire

Front Panel Components:

Pushbuttons Up to 8 gray rubber pushbuttons in a 4 x 2 matrix

LEDs • One per button (8 total)

• 6 Channel indicators

• 6+ indicator (2nd pack indicator)

• P (Program mode) indicator

Overlay Custom engraved; default is blank.

Rear Panel Components:

DIP switch 8-position DIP switch that sets the panel's Preset Offset values, Pack Offsets,

Preset/Channel selection, and programming features.

PROlink LED Green PROlink status LED indicates PROlink power/data status as follows:

• One blink every two seconds indicates power is active and PROlink

communication is working.

• Full On indicates power is active and PROlink communication is not functioning

properly.

If the PROlink LED remains On, check the connections or refer to

the Troubleshooting section on page 12.

PROlink bus connector Connects to a Radia dimmer Pack using a PROlink cable.

Wiring 4-conductor, AWG #18 @1,000 feet (304.8 m) max. wire length

Color Availability White or black panel with gray pushbuttons

Mounting Options • Wall mount fits into most standard US wallboxes

• Podium mount