User Guide

Product Information
2
PRO-DP16 Decor 16-Button PROlink Wall Panel
PRO-DP16 Overlay
FIG. 1 shows a standard PRO-DP16 overlay. There are no numbers or labels screened on a standard
blank overlay. The buttons and LED labels are shown here to describe their orientation. Custom
engraved overlays are available on request.
The following table describes the pushbuttons and LEDs and their associated functions:
FIG. 1 Standard PRO-DP16 overlay
PRO-DP16 Pushbuttons and LEDs
Pushbuttons (1-16):
1-10 (Presets buttons) When the panel is in default mode (all DIP switches off), these buttons are used
to recall programmed presets 1-10. You can configure the PRO-DP16 to allow all
panel pushbuttons (1-16) to be used as preset recall buttons, via the DIP switch
on the rear of the panel. For details, refer to the Using Switch 7 to Enable Either
Preset Recall mode, or Up/Down Ramping section on page 17.
11 (Clear) Clears a preset lighting level.
12 (Off) Turns off a selected preset. The Off button can be offset via the DIP for systems
with multiple panels. See the Using Switch 6 to Offset the Off Button section on
page 16 for details.
13 (Select) Cycles through channels/zones (1-6).
14 (Up) Ramps up the light level and Presets for the selected zone.
Press the Up and Down arrows simultaneously to enter Program mode.
15 (Down) Ramps down the light level and Presets for the selected zone.
Press the Up and Down arrows simultaneously to enter Program mode.
123456
CHANNEL
PGM PCK CRV LE
Low-end (LE) LED
Curve (CRV) LED
Pack (PCK) LED
Program (PGM) LED
Channel LEDs
(1-6)
1
59
13
26
10
14
3
7
11
15
4
8
12 16
Presets 1-10
Select
Up arrow
Down arrow
Mode
Clear
Off