User Guide

Product Information

PRO-DP16 Decor 16-Button PROlink Wall Panel

Product Information

The PRO-DP16 is a 16-button wall panel designed to directly control AMX Radia Lighting™

systems. It is a PROlink panel that gets its power and data from a Radia Lighting Controller

attached to the dimmer control cards. PROlink panels do not have addresses and can be chained

together with minimal setup requirements. Each wall panel provides individual control of up to 60

channels (zones) via up to 10 dimmer control cards connected via the PROlink bus.

The Decor style PRO-DP16 can store/recall Preset light levels, raise/lower light levels to create

scenes, ramp presets, set dimmer curves and low-end settings, and turn lights on/off. It fits in a 2-

gang wall box and is connected using a low-voltage 4-wire PROlink cable. PROlink panels are

connected directly to the dimmer controllers and work independently from AXlink or AMX

Central Controllers. It comes with a standard overlay that can be custom engraved for special uses,

and allows the removal of selected buttons if desired. The ability to recall different Presets from

different panels is done via rear panel DIP switch settings.

Specifications

Dimensions (HWD) 4.68" x 4.75" x 1.72" (11.87 cm x 12.05 cm x 4.36 cm)

Voltage 12 VDC; 85 mA maximum per panel

Weight 3.78 oz. (107.16 g)

Connector PROlink 4-pin data/power captive-wire

Front Panel Components:

Pushbuttons Up to 16 gray rubber pushbuttons in a 4 x 4 matrix

LEDs • One per button (16 total)

• 6 Channel indicators

• Program Mode indicator (PGM)

• Pack Mode indicator (PCK)

• Curve Mode indicator (CRV)

• Low-End Mode indicator (LE)

Overlay Custom engraved; default is blank.

Rear Panel Components:

DIP switch 8-position DIP switch that sets the Preset Offset values, Preset/Zone selection,

and programming features. Default = all off.

PROlink LED Green PROlink status LED indicates PROlink power/data status as follows:

• One blink every two seconds indicates power is active and PROlink

communication is working.

• Full On indicates power is active and PROlink communication is not functioning

properly.

If the PROlink LED remains On, check the connections or refer to

the Troubleshooting section on page 12.

PROlink bus connector Connects to a Radia dimmer Pack using a PROlink cable.

Wiring 4-conductor, AWG #18 @1,000 feet (304.8 m) max. wire length

Color Availability White or black panel with gray pushbuttons

Mounting Options • Wall mount fits into most standard US wallboxes

• Podium mount