Specifications

Installation
7
NXV-300 Modero Virtual Touch Panel
Installation
Wiring and Connections
The NXV-300 is installed to the NetLinx Master, and passes NetLinx control commands to the Master via
Ethernet 10/100 cable, as indicated in FIG. 3:
After you have completed the installation, consult the Setup Pages and Descriptions section on page 9.
Ethernet 10/100 Base-T RJ-45 Wiring Configuration
The table below describes the pinouts, signals, and pairing for the Ethernet 10/100 Base-T connector and
cable.
FIG. 4 diagrams the RJ-45 pinouts and signals for the Ethernet RJ-45 connector and cable.
To avoid any damage to the electronic component, installation must be performed in
an ESD safe environment.
FIG. 3 NXV-300 installation
Ethernet Pinouts and Signals
Pin Signals Connections Pairing Color
1 TX + 1 --------- 1 1 --------- 2 White-Orange
2 TX - 2 --------- 2 Orange
3 RX + 3 --------- 3 3 --------- 6 White-Green
4 no connection 4 --------- 4 Blue
5 no connection 5 --------- 5 White-Blue
6 RX - 6 --------- 6 Green
7 no connection 7 --------- 7 White-Brown
8 no connection 8 --------- 8 Brown
FIG. 4
Straight-Through Wiring
Ethernet 10/100
PoE injector
NetLinx Master
Ethernet Switch
NXV-300
Ethernet 10/100
To Touch Panel
To Laptop