Specifications

Setup Pages and Descriptions
18
NXV-300 Modero Virtual Touch Panel
Any use of the Reset Settings or Remove Pages buttons opens up the Confirmation Dialog window. The
Ye s button is grayed out for ten seconds while a timer reads down between it and the No button, and then
becomes enabled. Clicking either button will return you to the Protected Setup page.
Protected Setup Page Elements (Cont.)
Reset Settings: • Press this button to wipe out all current configuration parameters on the touch
panel (such as IP Addresses, Device Number assignments, Passwords, and
other presets).
- Pressing this button launches a Confirmation dialog which asks to confirm
your selection.
- This dialog is configured with a delay timer that does not enable the YES
button for 5 seconds. This delay provides an additional amount of time for
the user to confirm a decision.
Remove Pages: • Press this button to remove all current TPD4 touch panel pages currently on
the panel (including the pre-installed AMX Demo pages).
- Pressing this button launches a Confirmation dialog which asks to confirm
your selection.
- This dialog is configured with a delay timer that does not enable the YES
button for 5 seconds. This delay provides an additional amount of time for
the user to confirm a decision.
System Settings icon: • Press this button to configure communication settings between the NetLinx
Master and the panel.
G4 Web Control icon: • Press this button to allow for password protection. This controls access to the
NXV-300 pages, as well as specifying the maximum number of connected
users.
Passwords icon: • Press this button to access the Passwords Page (page 24).
Panel Statistics icon: • Press this button to access the Panel Statistics Page (page 25).
Connection Utility icon: • Press this button to access the Connection Utility Page (page 27).
Back: Saves the changes and returns to the previously active touch panel page.
FIG. 14
Protected Setup page-System Settings confirmation dialog