Technical information

Overview

NXR-ZGW-PRO NetLinx ZigBee Pro Gateway & NXR-ZRP-PRO NetLinx ZigBee Pro Repeater

NXR-ZRP-PRO NetLinx ZigBee Pro Repeater

FIG. 2 NXR-ZRP-PRO, front and rear

NXR-ZRP-PRO Specifications

Dimensions (HWD): • 906 x 2.500 x 3.424 (23.01 mm x 63.50 mm x 86.96 mm)

• Depth does not include antenna

Weight: • 0.25 lbs (113.39g)

Power: 10.5 - 18 VDC; 13.5 (nominal operation voltage)

Memory: • 1 Megabit external memory

• 128K microprocessor Flash memory

Radio Specifications: • Frequency: IEEE 802.15.4

• Operating channels: 11 - 26

• Modulation technique: DSS

• Output power: Region/country specific

• Coverage area (N America): 165 feet (50.2m)

Communications The NXR-ZRP-PRO communicates with a Netlinx master via a NXR-ZGW-

PRO. The NXR-ZGW-PRO communicates with a Netlinx master over TCP/IP

encapsulating the ICSP protocol via a physical Ethernet connection. The ICSP

device number can be set via the browser-based management interface.

Front Components:

LEDs • PWR/STATUS - A green LED that blinks to indicate the device is powered but

not commissioned to a network. A solid light indicates a device powered up

and commissioned; Power OFF is indicated with no light.

• ICSP - The LED is on when the device is connected to the gateway and off

when not connected.

• RF - The LED blinks when RF is active and is off when RF is inactive.

Antenna Mount A reverse SMA connection that supports a 2.4GHz antenna.

Reset Button Press and hold for approximately 10 seconds to return the NXR-ZRP-PRO to

factory default settings.

LEDs

Antenna

RESET Button

2-pin 3.5mm

PWR connector

Front Rear

Antenna

Antenna Mount