Technical information

Overview
2
NXR-ZGW-PRO NetLinx ZigBee Pro Gateway & NXR-ZRP-PRO NetLinx ZigBee Pro Repeater
NXR-ZGW-PRO Specifications (Cont.)
Radio Specifications: • Frequency: IEEE 802.15.4
• Operating channels: 1 - 26
• Modulation technique: DSS
• Output power: Region/country specific
• Coverage area (N America): 165 feet (50.2m)
IP Configuration: Static IP or DHCP client
• DHCP default: DHCP/ZeroConf
• Static IP default: 169.254.1.2
Communications: The NXR-ZGW-PRO communicates with a NetLinx master over TCP/IP 
encapsulating the ICSP protocol via a physical Ethernet connection.
The ICSP device number can be set via the browser-based configuration
pages (page 17).
Front Components:
LEDs • PWR/STATUS - A green LED that blinks every 5 seconds to indicate the
device is installed and communicating properly with the Master. Power ON,
but no Master connection, is indicated with a solid light; Power OFF is
indicated with no light.
• LAN - A green LED indicates an Ethernet connection is established. The LED
blinks to indicate both sending and receiving information via Ethernet.
• RF - The LED is solid when devices are connected; devices not connected is
indicated with no LED light; the LED blinks to indicate activity.
Antenna Mount A reverse SMA connection that supports a 2.4GHz antenna.
ID Button When used in conjunction with NetLinx Studio, sets the device and system
numbers for the NXR-ZGW-PRO.
Press and hold for approximately 30 seconds to return the NXR-ZGW-PRO to
factory default settings.
Rear Components:
Power connector Two power options are available:
• 2-pin 3.5mm captive-wire PWR connector
• Power Over Ethernet (PoE) - powers the device through the CAT5 cable.
Both Power and Data can be transmitted simultaneously through the CAT5
cable when using the appropriate equipment.
Ethernet port 10/100BaseT modular (RJ-45) connector - used to connect the 
NXR-ZGW-PRO to your LAN and/or to connect your third party device to the
LAN when the NXR-ZGW-PRO is used as a gateway.
Certifications: • FCC ID: CWU-NXRZGWPRO
• IC: 5078B-ZGWPRO
•CE
• IEC-60950-1
• Japan Approval
• ZigBee Certified
Operating/Storage
Environments:
• Operating Temperature: -30°C (-22°F) to 70°C (158°F)
• Relative Humidity: 5% to 85% non-condensing
• Intended for indoor use only
Included Accessories: • NXR-ZGW Installation Guide (93-5791-11)
• 2.4GHZ, MONO, RSMA, 3.5IN, 2.0DBI Antenna (70-0012-SA)
• Rubber feet
• Velcro mounting strip
• Power Supply (24-5791-SA)
Other AMX Products: • Mio Modero R-3 Remote (FG148-03)
• Mio Modero R-4 Remote (FG148-04)
• NXR-ZRP-PRO NetLinx ZigBee Repeater (FG5791-03)