User Manual
Table Of Contents
- NXR-ZGW/-ZRPNetLinx ZigBee Compatible Gatewayand Repeater
- Overview
- Installation
- Setting up a Network
- NXR-ZGW Browser-based Configuration Manager Pages
- Summary of Gateway Settings
- Configuration
- Personal Area Network (PAN)
- Network
- Enabling and disabling the wireless network
- Setting the PAN channel
- Security
- Access List
- Connections
- Finding a device’s EUI address
- Finding the device’s description
- Determining the device type
- Finding the amount of time a signal takes from the device to the gateway and back
- Determining the device link quality
- Checking the device link status
- PAN Device Details
- Putting a device on the Access List
- Removing a device from the Access List
- Locating the device
- Changing a Connected Device description
- Changing a device’s ZigBee networking information
- Utilities
- Device Configuration
Overview
3
NXR-ZGW/-ZRP
NXR-ZRP Specifications
The following table outlines the specifications for the NXR-ZRP.
NXR-ZRP (FG5791-02) Specifications
Dimensions (HWD): • 906 x 2.500 x 3.424 (23.01 mm x 63.50 mm x 86.96 mm) depth does not
include antenna
Weight: • 0.25 lbs (113.39g)
Power: 10.5 - 18 VDC; 13.5 (nominal operation voltage)
Memory: • 16 Mbytes of Flash
• 16 Mbytes of SDRAM
Radio Specifications:
Frequency
IEEE 802.15.4
Operating channels
• 11 - 26
Data Rate • 250 kbps (@2.4 GHz)
Modulation technique
•DSS
Security
• EUI Address filtering
Output power
• Country-specific: may be set from 0 dbm to 20 dbm
Coverage area 50m typical (5-500m based on environment)
Firmware/Software
Specifications:
Communications The NXR-ZRP communicates with a Netlinx master via a NXR-ZGW. The
NXR-ZGW communicates with a Netlinx master over TCP/IP encapsulating the
ICSP protocol via a physical Ethernet connection. The ICSP device number
can be set via the browser-based management system.
Front Components:
LEDs • PWR/STATUS - A green LED that blinks to indicate the device is
programmed and communicating properly. Power ON, but no master
connection, is indicated with a solid light; Power OFF is indicated with no
light.
• ICSP - The LED is solid when ICSP connection is in place with the NetLinx
master.
• RF - The LED is solid when end devices are connected; end devices not
connected is indicated with no LED light; the LED blinks to indicate activity.
Antenna Mount A reverse SMA connection that supports a 2.4GHz antenna.
Reset Button Press and hold for approximately 30 seconds to return the NXR-ZRP to factory
default settings.
Rear Components:
Power connector • 2-pin 3.5mm Phoenix connector
Certifications: • FCC ID: CWU-ZRD
• IC ID: 5088A-ZRD
•CE
• IEC-60590
Operating/Storage
Environments:
• Operating Temperature: -30°C (-22°F) to 70°C (158°F)
• Relative Humidity: 5% to 85% non-condensing; intended for indoor use only
Included Accessories: • 2.4GHZ, MONO, RSMA, 3.5IN, 2.0DBI Antenna (70-0012-SA)
• Rubber feet
• Velcro mounting strip